Feature Codes - Grandstream Networks UCM6100 Series User Manual

Feature Code Digits Timeout
Call Park
Parked Lots
Use Parklot as Extension
Parking Timeout (s)
Feature Codes
Voicemail A ccess Code
My Voicemail
Agent Pause
Agent Unpause
Paging Prefix
Intercom Prefix
Firmware Version 1.0.9.26
Default Setting: 1000.
•
Configure the maximum interval (in milliseconds) between the
•
digits input to activate the feature code.
Default Extension: 700.
•
During an active call, initiate blind transfer and then enter this
•
code to park the call.
Default Extension: 701-­720.
•
These are the extensions where the calls will be parked, i.e.,
•
parking lots that the parked calls can be retrieved.
If checked, the parking lot number can be used as extension.
•
The user can transfer the call to the parking lot number to park
the call. Please note this parking lot number range might
conflict with extension range.
Default setting: 300.
•
This is the timeout allowed for a call to be parked. After the
•
timeout, if the call is not picked up, the extension who parks the
call will be called back.
Default Code: *98.
•
Enter *98 and follow the voice prompt. Or dial *98 followed by
•
the extension and # to access the entered extension's
voicemail box.
Default Code: *97.
•
Press *97 to access the voicemail box.
•
Default Code: *83.
•
Pause the agent in all call queues.
•
Default Code: *84.
•
Unpause the agent in all call queues.
•
Default Code: *81.
•
To page an extension, enter the code followed by the extension
•
number.
Default Code: *80.
•
To intercom an extension, enter the code followed by the
•
extension number.
UCM6100 Series IP PBX User Manual Page 244 of 304