CallerID Name
Username
Password
Advanced Settings
Codec Preference
Enable Qualify
Qualify Timeout
Qualify Frequency
Maximum Number of Call Lines
Fax Mode
Basic Settings
Provider Name
Firmware Version 1.0.9.26
When making outgoing calls, the following rules are used to determine
which CallerID will be used if they exist:
The CallerID configured for the extension will be looked up first.
•
If no CallerID configured for the extension, the CallerID configured for
•
the trunk will be used.
If the above two are missing, the "Global Outbound CID" defined in
•
Web GUI->PBX->Internal Options->General will be used.
Configure the name of the caller to be displayed when the extension has
no CallerID Name configured.
Enter the username to register to the trunk from the provider.
Enter the password to register to the trunk from the provider.
Select audio and video codec for the VoIP trunk. The available codecs
are: PCMU, PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723,
iLBC, A DPCM, H.264, H.263, H.263p.
If enabled, the UCM6100 will regularly send SIP OPTIONS to the device
to check if the device is still online. The default setting is "No".
When "Enable Qualify" option is set to "Yes", configure the timeout (in ms)
for the Qualify SIP message. If no response is received within the timeout,
the device is considered offline. The default setting is 1000ms.
When "Enable Qualify" option is set to "Yes", configure the interval (in
seconds) of the SIP OPTIONS message sent to the device to check if the
device is still online. The default setting is 60 seconds.
The maximum number of concurrent calls using the trunk. The default
settings 0, which means no limited.
Select Fax mode. The default setting is "None".
None: Disable Fax.
•
Fax Detect: Fax signal from the user/trunk during the call can be
•
detected and the received Fax will be sent to the Email address
configured for this extension. If no Email address can be found for the
user, the Fax will be sent to the default Email address configured in
Fax setting page under web UI->PBX->Internal Options->Fax/T.38.
Table 55: IAX Peer Trunk Configuration Parameters
Configure a unique label to identify this trunk when listed in outbound
rules, inbound rules and etc.
UCM6100 Series IP PBX User Manual
Page 162 of 304