Table of Contents
Advertisement
HandyTone-496 User Manual
6.1 Configuring HandyTone-496 WAN IP through Voice Prompt
6.1.1 DHCP Mode
Follow section 5.1 with voice menu option 01 to enable HandyTone-496 to use DHCP.
6.1.2 STATIC IP Mode
Follow section 5.1 with voice menu option 01 to enable HandyTone-496 to use STATIC IP mode, then
use option 02, 03, 04, 05 to set up IP address, Subnet Mask, Gateway and DNS server respectively.
6.1.3 TFTP Server Address
Follow section 5.1 with voice menu option 06 to configure the IP address of the TFTP firmware and
configuration file server.
6.2 Configuring HandyTone-496 with Web Browser
HandyTone-496 has an embedded Web server that will respond to HTTP GET/POST requests. It also
has embedded HTML pages that allow users to configure the HandyTone-496 through a Web browser
such as Microsoft's IE and AOL's Netscape.
6.2.1 Access the Web Configuration Menu
The HandyTone-496 HTML configuration menu can be accessed via LAN or WAN port:
• From the LAN port:
Directly connect a computer to the LAN port.
Open a command window on the computer
Type in "ipconfig /release", the IP address etc. becomes 0.
Type in "ipconfig /renew", the computer gets an IP address in 192.168.2.x segment by
default
Open a web browser, type in the default gateway IP address. You will see the login
page of the device.
• The WAN port HTML configuration option is disabled by default from factory. To access the
HTML configuration menu from the WAN port, first enable the "WAN side HTTP access"
6
Configuration Guide
http://192.168.2.1
Grandstream Networks, Inc
16
.
Advertisement
Table of Contents
