Connect The Ucm6116; Figure 6: Ucm6108 Front View; Figure 7: Ucm6108 Back View; Figure 8: Ucm6116 Front View - Grandstream Networks UCM6100 Series User Manual

CONNECT T HE U CM6116
To set up the UCM6116, follow the steps below:
1. Connect one end of an RJ-­45 Ethernet cable into the LAN port of the UCM6116.
2. Connect the other end of the Ethernet cable into the uplink port of an Ethernet switch/hub.
3. Connect the 12V DC power adapter into the 12V DC power jack on the back of the UCM6116. Insert
the main plug of the power adapter into a surge-­protected power outlet.
4. Wait for the UCM6116 to boot up. The LCD in the front will show the device hardware information
when the boot process is done.
Firmware Version 1.0.9.26
Figure 6: UCM6108 Front View
Figure 7: UCM6108 Back View
Figure 8: UCM6116 Front View
Figure 9: UCM6116 Back View
UCM6100 Series IP PBX User Manual Page 34 of 304