Iax Settings; Iax Settings/General; Iax Settings/Registration; Table 82: Iax Settings/General - Grandstream Networks UCM6100 Series User Manual

The UCM6100 IAX global settings can be accessed via Web GUI-­>PBX-­>IAX Settings.
IAX S ETTINGS/GENERAL
Bind Port
Bind A ddress
IAX1 Compatibility
No Checksums
Delay Reject
ADSI
Music On Hold Interpret
Music On Hold Suggest
Bandwidth
IAX S ETTINGS/REGISTRATION
IAX Registration Options
Min Reg Expire
Max Reg Expire
IAX Thread Count
IAX Max Thread Count
Firmware Version 1.0.9.26
IAX S ETTINGS
Table 82: IAX Settings/General
Configure the port number that the IAX2 will be allowed to listen to. The
default setting is 4569.
Configure the address that the IAX2 will be forced to bind to. The default
setting is 0.0.0.0, which means all addresses.
Select to configure IAX1 compatibility. The default setting is "No".
If selected, UDP checksums will be disabled and no checksums will be
calculated/checked on systems supporting this features. The default
setting is "No".
If enabled, the IAX2 will delay the rejection of calls to avoid DOS. The
default setting is "No".
Select to enable A DSI phone compatibility. The default setting is "No".
Specify which Music On Hold class this channel would like to listen to
when being put on hold. This music class is only effective if this channel
has no music class configured and the bridged channel putting the call on
hold has no "Music On Hold Suggest" setting.
Specify which Music On Hold class to suggest to the bridged channel
when putting the call on hold.
Configure the bandwidth for IAX settings. The default setting is "Low".
Table 83: IAX Settings/Registration
Configure the minimum period (in seconds) of registration. The default
setting is 60.
Configure the maximum period (in seconds) of registration. The default
setting is 3600.
Configure the number of IAX helper threads. The default setting is 10.
Configure the maximum number of IAX threads allowed. The default
setting is 100.
UCM6100 Series IP PBX User Manual Page 256 of 304