Grandstream Networks UCM6100 Series User Manual page 246

Blacklist A dd
Blacklist Remove
Call Pickup on Ringing
Pickup Extension
Direct Dial Voicemail Prefix
Call Completion Request
Call Completion Cancel
Enable Spy
Listen Spy
Whisper Spy
Firmware Version 1.0.9.26
Default Code: *40.
•
To add a number to blacklist for inbound route, dial *40 and
•
follow the voice prompt to enter the number.
Default Code: *41.
•
To remove a number from current blacklist for inbound route,
•
dial *41 and follow the voice prompt to remove the number.
Default Code: **.
•
To pick up a call for any extension xxxx, enter the code followed
•
by the extension number xxxx.
Default Code: *8.
•
This code is for the pickup group which can be assigned for
•
each extension on the extension configuration page.
If there is an incoming call to an extension, the other
•
extensions within the same pickup group can dial *8 directly to
pick up the call.
Default Code: *
•
This code is for the user to directly dial or transfer to an
•
extension's voicemail.
For example, directly dial *5000 will have to call go into the
•
extension 5000's voicemail. If the user would like to transfer the
call to the extension 5000's voicemail, enter *5000 as the
transfer target number.
Default Code: *11
•
This code is for the user who wants to use Call Completion to
•
complete a call.
Default Code: *12
•
This code is for the user who wants to cancel Call Completion
•
request.
Check this box to enable spy feature codes.
This is the feature code to listen in on a call to monitor
performance. Monitor's line will be muted, and neither party will
hear from the monitor's extension. The default setting is *54.
This is the feature code to speak to one side of the call (for
example, whisper to employees to help them handle a call).
Only one side will be able to hear from the monitor's extension.
The default setting is *55.
UCM6100 Series IP PBX User Manual Page 245 of 304