VALUE-‐‑ A DDED
F EATURES
FAX
S ENDING
The UCM6100 supports sending Fax via web UI access. This feature can be found on web
UI->PBX->Value-added Features->Fax Sending page. In order to send fax, pre-setup for analog trunk
and outbound route is required. Please refer to
and
[ANALOG TRUNKS], [VOIP TRUNKS]
[OUTBOUND
sections for configuring analog trunk and outbound route.
ROUTES]
After making sure analog trunk or VoIP Trunk is setup properly and UCM6100 can reach out to PSTN
numbers via the trunk, on Fax Sending page, enter the fax number and upload the file to be faxed. Then
click on "Send" to start. The progress of sending fax will be displayed in web UI. Users can also view the
sending history is in the same web page.
Figure 147: Fax Sending in Web UI
Firmware Version 1.0.9.26
UCM6100 Series IP PBX User Manual
Page 264 of 304