Preferred DNS Server
LAN (when Method is set to "Switch")
IP Method
IP A ddress
Subnet Mask
Gateway IP
DNS Server 1
DNS Server 2
User Name
Password
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
LAN 1 / LAN 2 (when Method is set to "Dual")
Default Interface
IP Method
IP A ddress
Subnet Mask
Gateway IP
DNS Server 1
DNS Server 2
User Name
Password
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
Preferred DNS Server
Firmware Version 1.0.9.26
Enter the preferred DNS server address. If Preferred DNS is used, UCM will try to
use it as Primary DNS server.
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Enter the subnet mask address for static IP settings. The default setting is
255.255.0.0.
Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
Enter the DNS server 1 address for static IP settings. The default setting is
0.0.0.0.
Enter the DNS server 2 address for static IP settings.
Enter the user name to connect via PPPoE.
Enter the password to connect via PPPoE.
Assign the VLAN tag of the layer 2 QoS packets for LAN port. The default value is
0.
Assign the priority value of the layer 2 QoS packets for LAN port. The default
value is 0.
If "Dual" is selected as "Method", users will need assign the default interface to be
LAN 1 or LAN 2. The default interface is LAN 2.
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Enter the subnet mask address for static IP settings. The default setting is
255.255.0.0.
Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
Enter the DNS server 1 address for static IP settings. The default setting is
0.0.0.0.
Enter the DNS server 2 address for static IP settings.
Enter the user name to connect via PPPoE.
Enter the password to connect via PPPoE.
Assign the VLAN tag of the layer 2 QoS packets for LAN port. The default value is
0.
Assign the priority value of the layer 2 QoS packets for LAN port. The default
value is 0.
Table 11: UCM6108/UCM6116 Network Settings->Basic Settings
Enter the preferred DNS server address. If Preferred DNS is used, UCM will try to
UCM6100 Series IP PBX User Manual
Page 55 of 304