Table 25: Auto Provision Settings; Figure 60: Auto Provision Settings - Grandstream Networks UCM6100 Series User Manual

Enable Zero Config
Enable A utomatic
Configuration A ssignment
Automatically A ssign Extension
Zero Config Extension
Segment
Enable Pick Extension
Firmware Version 1.0.9.26
Figure 60: Auto Provision Settings
Table 25: Auto Provision Settings
Enable or disable the zero config feature on the PBX. The default setting
is enabled.
By default, this is disabled. If disabled, when SIP device boots up, the
UCM6100 will not send the SIP device the URL to download the config file
and therefore the SIP device will not be automatically provisioned by the
UCM6100.
Note:
When disabled, SIP devices can still be provisioned by manually sending
NOTIFY from the UCM6100 which will include the XML config file URL for
the SIP device to download.
If enabled, when the device is discovered, the PBX will automatically
assign an extension within the range defined in "Zero Config Extension
Segment" to the device. The default setting is disabled.
Click on the link "Zero Config Extension Segment" to specify the
extension range to be assigned if "Automatically Assign Extension" is
enabled. The default range is 5000-­6299. Zero Config Extension
Segment range can be defined in web UI-­>PBX-­>Internal
Options-­>General page-­>Extension Preference section: "Auto Provision
Extensions".
If enabled, the extension list will be sent out to the device after receiving
UCM6100 Series IP PBX User Manual Page 94 of 304