Grandstream Networks UCM6100 Series User Manual page 233
Ip pbx
Hide thumbs
Also See for UCM6100 Series:
- User manual (418 pages) ,
- Manual manual (24 pages) ,
- Configuration (19 pages)
Table of Contents
Advertisement
Note:
To configure LDAP sync, please go to UCM6100 web GUI->PBX->Basic/Call Routes->VoIP Trunk.
•
You will see "Sync LDAP Enable" option. Once enabled, please configure password information for the
remote peer UCM6100 to connect to the local UCM6100. Additional information such as port number,
LDAP outbound rule, LDAP Dialed Prefix will also be required. Both the local UCM6100 and remote
UCM6100 need enable LDAP sync option with the same password for successful connection and
synchronization.
Currently LDAP sync feature only works between two UCM6100s.
•
(Theoretically) Remote BLF monitoring will work when the remote PBX being monitored is
•
non-UCM6100 PBX. However, it might not work the other way around depending on whether the
non-UCM6100 PBX supports event list BLF or remote monitoring feature.
--------------------------------------------------------------------------------------------------------------------------------------------
Firmware Version 1.0.9.26
UCM6100 Series IP PBX User Manual
Page 232 of 304
Advertisement
Table of Contents
Troubleshooting
