Grandstream Networks UCM6100 Series User Manual page 24

options for network port settings are added. [NETWORK SETTINGS]
Updated LDAP client configurations information.
•
Added sample Email settings. [EMAIL SETTINGS]
•
Added manual time settings. [TIME SETTINGS]
•
Added "Enable Pick Extension" and "Extension Segment" options for auto provisioning settings.
•
Changed one of the discovery method from "SIP MESSAGE (OPTIONS)" to "SIP MESSAGE
•
(NOTIFY)" in zero-­config feature.
Added pickup group feature. [Table 75: UCM6100 Feature Codes]
•
Added PSTN detection instructions for "Auto Detect" and "Semi-­auto Detect". [PSTN
•
DETECTION]
Added "Auth ID" option for SIP register trunk configuration. [Table 50: Create New SIP Trunk]
•
Added LDAP sync options for peer SIP trunk. [Table 50: Create New SIP Trunk]
•
Changed the default setting of outbound route "Privilege Level" from "Internal" to "International" to
•
avoid potential misconfiguration and security risk.
Added DISA and Fax to IVR key press event options. [Table 61: IVR Configuration Parameters]
•
Added "Min Message Time" option in voicemail settings. [Table 62: Voicemail Settings]
•
Added Fax setting samples. [FAX/T.38]
•
Added DISA support for inbound route and IVR.
•
Added Event List support to monitor local extensions and remote extensions. [BLF AND EVENT
•
LIST]
Added feature code *0 for "Disconnect". [Table 75: UCM6100 Feature Codes]
•
Added feature code *8 for "Pickup Extension" in pickup group feature. [Table 75: UCM6100
•
Feature Codes]
Added "Record Prompt" and "Custom Name of Pickup Group" options in internal options. [Table
•
76: Internal Options/General]
Added warning information for "Allow Guest Call" option to avoid potential security risk caused by
•
misconfiguration. [Table 82: IAX Settings/General]
Changed reset mode to two mode "User Data" and "All". [RESET A ND REBOOT]
•
FIRMWARE V ERSION 1 .0.1.22
This is the initial version.
•
Firmware Version 1.0.9.26 UCM6100 Series IP PBX User Manual Page 23 of 304