Grandstream Networks UCM6100 Series User Manual page 127

CC Mode
CC Max A gents
CC Max Monitors
Ring Simultaneously
Ring Simultaneously
External Number
Time Condition for Ring
Simultaneously
Other Settings
Ring Timeout
Auto Record
Skip Trunk A uth
Firmware Version 1.0.9.26
party is available, given that a previous call to that party failed for some
reason. By default it's disabled.
Two modes for Call Completion are supported:
Normal: This extension is used as ordinary extension.
•
For Trunk: This extension is registered from a PBX.
•
The default setting is "Normal".
Configure the maximum number of CCSS agents which may be allocated
for this channel. In other words, this number serves as the maximum
number of CC requests this channel is allowed to make. The minimum
value is 1.
Configure the maximum number of monitor structures which may be
created for this device. In other words, this number tells how many callers
may request CC services for a specific device at one time. The minimum
value is 1.
Enable this option to have an external number ring simultaneously along
with the extension. If a register trunk is used for outbound, the register
number will be used to be displayed for the external number as caller ID
number.
Set the external number to be rang simultaneously. '-­' is the connection
character which will be ignored.
Ring the external number simultaneously along with the extension on the
basis of this time condition.
Configure the number of seconds to ring the user before the call is
forwarded to voicemail (voicemail is enabled) or hang up (voicemail is
disabled). If not specified, the default ring timeout is 60 seconds on the
UCM6100, which can be configured in the global ring timeout setting
under web GUI-­>Internal Options-­>IVR Prompt: General Preference. The
valid range is between 5 seconds and 600 seconds.
Note:
If the end point also has a ring timeout configured, the actual ring timeout
used is the shortest time set by either device.
Enable automatic recording for the calls using this extension. The default
setting is disabled. The recording files can be accessed under web
GUI-­>CDR-­>Recording Files.
· If set to 'yes', users can skip entering the password when making
outbound calls.
· If set to 'By Time', users can skip entering the password when making
UCM6100 Series IP PBX User Manual Page 126 of 304