Sending And Receiving Fax; Configuration Guide; Configuring The Ht-502 Via Voice Prompts; Dhcp Mode - Grandstream Networks HT– 502 User Manual

S R
ENDING AND ECEIVING
HT–502 supports fax in two modes: 1) T.38 (Fax over IP) and 2) fax pass through.
T.38 is the preferred method because it is more reliable and works well in most network conditions. If the
service provider supports T.38, please use this method by selecting T.38 as fax mode (default). If the
service provider does not support T.38, pass-through mode may be used. If you have problems with
sending or receiving Fax, toggle the Fax Tone Detection Mode setting.
C
ONFIGURATION
C T HT–502 V
ONFIGURING HE
DHCP M
ODE
Select voice menu option 01 to enable HT–502 to use DHCP.
STATIC IP M
ODE
Select voice menu option 01 to enable HT–502 to use STATIC IP mode, then use option 02, 03, 04, 05 to
set up IP address, Subnet Mask, Gateway and DNS server respectively.
F S IP A
IRMWARE ERVER
Select voice menu option 13 to configure the IP address of the firmware server.
C S
ONFIGURATION ERVER
Select voice menu option 14 to configure the IP address of the configuration server.
U P
PGRADE ROTOCOL
Select voice menu option 15 to choose firmware and configuration upgrade protocol. User can choose
between TFTP and HTTP.
F U M
IRMWARE PGRADE
Select voice menu option 17 to choose firmware upgrade mode among the following three options: 1)
always check, 2) check when pre/suffix changes, and 3) never upgrade
WAN P W A
ORT EB CCESS
Select voice menu option 12 to enable WAN Port Wed Access of the device configuration pages.
Grandstream Networks, Inc.
F
AX
G
UIDE
V P
IA OICE
DDRESS
IP A
DDRESS
ODE
HT-502 User Manual
ROMPTS
Firmware 1.0.0.39
Page 14 of 35
Last Updated: 03/2007