Grandstream Networks UCM6100 Series User Manual page 263

ToS For RTP A udio
ToS For RTP Video
Default Incoming/Outgoing
Registration Time
Max Registration/Subscription
Time
Min Registration/Subscription
Time
Music On Hold Interpret
Music On Hold Suggest
Enable Relaxed DTMF
DTMF Mode
RTP Timeout
RTP Hold Timeout
Trust Remote Party ID
Send Remote Party ID
Generate In-­Band Ringing
Firmware Version 1.0.9.26
None.
Configure the Type of Service for RTP audio packets. The default setting
is None.
Configure the Type of Service for RTP video packets. The default setting
is None.
Configure the default duration (in seconds) of incoming/outgoing
registration. The default setting is 120.
Configure the maximum duration (in seconds) of incoming registration
and subscription allowed by the UCM6100. The default setting is 3600.
Configure the minimum duration (in seconds) of incoming registration and
subscription allowed by the UCM6100. The default setting is 60.
Configure the Music On Hold class for the channel when being put on
hold. This is used when the Music On Hold class is not set on the channel
and the peer channel placing the call on hold doesn't have "Music On
Hold Suggest".
Configure the Music On Hold class to suggest to the peer channel when
placing the peer on hold.
Select to enable relaxed DTMF handling. The default setting is "No".
Select DTMF mode to send DTMF. The default setting is RFC2833. If
"Info" is selected, SIP INFO message will be used. If "Inband" is selected,
64-­kbit codec PCMU and PCMA are required. When "Auto" is selected,
"RFC2833" will be used if offered, otherwise "Inband" will be used. The
default setting is "RFC2833".
During an active call, if there is no RTP activity within the timeout (in
seconds), the call will be terminated. The default setting is no timeout.
Note:
This setting doesn't apply to calls on hold.
When the call is on hold, if there is no RTP activity within the timeout (in
seconds), the call will be terminated. This value of RTP Hold Timeout
should be larger than RTP Timeout. The default setting is no timeout.
Configure whether the Remote-­Party-­ID should be trusted. The default
setting is "No".
Configure whether the Remote-­Party-­ID should be sent or not. The
default setting is "No".
Configure whether the UCM6100 should generate inband ringing or not.
The default setting is "Never".
Yes: The UCM6100 will send 180 Ringing followed by 183 Session
•
UCM6100 Series IP PBX User Manual Page 262 of 304