Inbound Rule Configurations; Table 58: Inbound Rule Configuration Parameters - Grandstream Networks UCM6100 Series User Manual

Click on to delete the inbound route.
•
INBOUND R ULE C ONFIGURATIONS
Trunks
DID Pattern
Privilege Level
Default Destination
Firmware Version 1.0.9.26
Table 58: Inbound Rule Configuration Parameters
Select the trunk to configure the inbound rule.
All patterns are prefixed with the "_".
•
Special characters:
•
X: A ny Digit from 0-­9.
Z: A ny Digit from 1-­9.
N: A ny Digit from 2-­9.
".": Wildcard. Match one or more characters.
"!": Wildcard. Match zero or more characters immediately.
Example: [12345-­9] -­ A ny digit from 1 to 9.
The pattern can be composed of two parts, divided by a '/' character.
•
The first part is used to specify the dialed number the second part is
used to specify the caller ID and it is optional, if set it means only the
extension with the specific caller ID is allowed to call in or call out.
For example, patter '_2XXX/1234' means the only extension with the
caller ID '1234' is allowed to use this rule.
Configure the privilege level for this inbound route.
Select the default destination for the inbound call.
Extension
•
Voicemail
•
Conference Room
•
Queue
•
Ring Group
•
Paging/Intercom
•
Voicemail Group
•
Fax
•
DISA
•
IVR
•
Dial By Name
•
External Number
•
By DID
•
When "By DID" is used, the UCM6100 will look for the destination
based on the number dialed, which could be local extensions,
conference, call queue, ring group, paging/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
UCM6100 Series IP PBX User Manual Page 173 of 304