Configuring Inbound Route Privilege; Figure 3: Create An Inbound Route On Ucm6100 - Grandstream Networks UCM6100 Configuring Permission

CONFIGURING INBOUND ROUTE PRIVILEGE

When creating a new inbound rule under PBX->Basic/Call Routes->Inbound Routes, users shall see
"Privilege Level" option with four levels in the drop down list.

Figure 3: Create an Inbound Route on UCM6100

This "Privilege Level" option applies to the inbound rule only when "Default Destination" is set to "by DID".
(IVR is handled in a different way; the other options in the "Default Destination" can be considered as
internal extension on the UCM6100)
When there is an inbound call from the trunk to the UCM6100 via this inbound route, the UCM6100 will
compare the inbound route's privilege level with the matching outbound route's privilege level (i.e, the DID
pattern in this inbound route matches one of the outbound route). If the inbound route's privilege level is
higher than (or equal to) the matching outbound route's privilege level, the call will be allowed to go
through.
Firmware Version 1.0.1.25 Configuring Permission/Privilege Level Settings on UCM6100 Page 6 of 7