Configure Inbound Rule On Ucm6100; Configure Fxo Port On Ht503; Figure 14: Method 2 - Configure Inbound Rule On The Ucm6100 - Grandstream Networks UCM6100 Series Configuration
Hide thumbs
Also See for UCM6100 Series:
- User manual (418 pages) ,
- Manual manual (24 pages) ,
- Cdr and rec api manual (18 pages)
Table of Contents
Advertisement
In this example "91XXXXXXXXXX", 9 is the first dialing digit and it will be stripped off when the call goes
out.
Configure Inbound Rule on UCM6100
On the UCM6100 web GUI, go to PBX->Basic/Call Routes->Inbound Routes to create a new inbound
rule.
In this example, we create the DID as 20000, which will be used in the HT503 call forward setting.
The default destination is configured to IVR.
Configure FXO Port on HT503
1. Connect the PSTN line to the HT503 FXO port.
2. On the HT503 web GUI, go to FXO Port setting page, configure to register the FXO port to the
UCM6100 extension 5000. Please refer to the highlighted settings and other necessary settings in the
following figures.
In this example, the UCM6100 IP address is 192.168.40.207.
Firmware Version 1.0.1.25
Figure 14: Method 2 - Configure Inbound Rule on the UCM6100
Configuring UCM6100 Series with HT503
Page 14 of 18
Advertisement
Table of Contents
