Planet Networking & Communication WGS3-24000 User Manual page 192

IP DSCP Traffic Class - Specify which internal traffic class to map the corresponding IP DSCP value. Valid Range is
。
(0 to 7) .
Non-Configurable Data
。 Untrusted Traffic Class - Displays traffic class (i.e. queue) to which all traffic is directed when in 'untrusted' mode.
Valid Range is (0 to 7).
Non-IP Traffic Class - Displays traffic class (i.e. queue) to which all non-IP traffic is directed when in 'trust
。
ip-precedence' or 'trust ip-dscp' mode. Valid Range is (0 to 7).
。 802.1p Priority - Displays the 802.1p priority to be mapped.
IP Precedence Value - Displays IP Precedence value. Valid Range is (0 to 7).
。
。 IP DSCP Value - Displays IP DSCP value. Valid Range is (0 to 63).
Command Buttons
。 Submit - Send the updated configuration to the switch. Configuration changes take effect immediately. These
changes will not be retained across a power cycle unless a save is performed.
。 Restore Defaults - Restores default settings.
4.5.5.2 IP Precedence Mapping Configuration
This page is to configure the IP Precedence mapping on the port.
Slot.Port - Select the physical interface for which you want to display or configure data. Select 'All' to set the
。
parameters for all ports to the same values.
Figure 4-5-27 IP Precedence Mapping Configuation
192