Table of Contents
Advertisement
13.1.14 show ip mcast mroute static
This command displays all the static routes configured in the static mcast table if is specified or displays the static route
associated with the particular <sourceipaddr>.
▫
Format
show ip mcast mroute static [<sourceipaddr>]
▫
Modes
Privileged EXEC User EXEC
Source Address
Source Mask
RPF Address
Metric
Unit/Slot/Port
13.1.15 show mrinfo
This command is used to display the neighbor information of a multicast-capable router from the results buffer pool of the router
subsequent to the execution/completion of a "mrinfo [ipaddr]" command. The results subsequent to the completion of the latest
"mrinfo" will be available in the bufferpool after a maximum duration of two minutes after the completion of the 'show mrinfo'
command. A subsequent issue 'mrinfo' will overwrite the contents of the buffer pool with fresh results.
▫
Default
none
▫
Format
show mrinfo
▫
Mode
Privileged EXEC
Router Interface
Neighbor
Metric
TTL
Flags
13.1.16 show mstat
This command is used to display the results of packet rate and loss information from the results buffer pool of the router,
subsequent to the execution/completion of a 'mstat <source> [group] [receiver]' command. Within two minutes of the completion
of the 'mstat' command, the results will be available in the buffer pool. The next issuing of "mstat" would overwrite the buffer pool
This field displays the IP address of the multicast packet source.
This field displays the mask applied to the IP address of the multicast packet source.
This field displays the IP address to be used as RPF for the given source and mask.
This field displays the metric value corresponding to the source address.
Valid unit, slot and port number separated by forward slashes.
The IP address of this neighbor
The neighbor associated with the router interface
The metric value associated with this neighbor
The TTL threshold associated with this neighbor
Status of the neighbor
491
Advertisement
Table of Contents
