Planet Networking & Communication WGS3-24000 User Manual page 270

Search - Search the Mroute table for an entry matching the Source IP (if entered) and Group IP address.
o
Clear Route - Remove the data on the screen for the Source IP (if entered) and Group IP address you have
o
specified.
Clear All - Remove all the data on the screen.
o
Refresh - Refresh the information on the screen with the present state of the data in the router.
o
4.7.1.4 Multicast Static Routes Configuration
Selection Criteria
Source - Select Create Static Route to configure a new static entry in the Mroute table, or select one of the existing
o
entries from the pulldown menu.
Configurable Data
Source IP - Enter the IP Address that identifies the multicast packet source for the entry you are creating.
o
Source Mask - Enter the subnet mask to be applied to the Source IP address.
o
RPF Neighbor - Enter the IP address of the neighbor router on the path to the source.
o
Metric - Enter the link state cost of the path to the multicast source. The range is 0 - 255 and the default is one. You
o
can change the metric for a configured route by selecting the static route and editing this field.
Figure 4-6-52 Multicast static Routes Configuration
270