Planet Networking & Communication WGS3-24000 User Manual page 134

4.3.8.1 Spanning Tree Switch Configuration/Status
This page is to enable/disable the Spanning Tree protocol. The switch support IEEE 802.1d Spanning Tree (STP), IEEE 802.1w
Rapid Spanning Tree (RSTP) and IEEE 802.1S Multiple Spanning Tree (MSTP).
Configurable Data
Spanning Tree Mode - Specifies whether spanning tree operation is enabled on the switch.
。
Value is enabled or disabled
Force Protocol Version - Specifies the Force Protocol Version parameter for the switch.
。
The options are IEEE 802.1d, IEEE 802.1w and IEEE 802.1s
Configuration Name- Identifier used to identify the configuration currently being used. It may be up to 32
。
alphanumeric characters
Configuration Revision Level - Identifier used to identify the configuration currently being used. The values
。
allowed are between 0 and 65535.
The default value is 0.
Non-Configurable Data
Configuration digest key - Identifier used to identify the configuration currently being used.
。
MST Table - Table consisting of the MST instances (including the CST) and the corresponding VLAN IDs
。
associated with each of them.
VID Table - Table consisting of the VLAN IDs and the corresponding FID associated with each of them.
。
FID Table - Table consisting of the FIDs and the corresponding VLAN IDs associated with each of them.
。
Figure 4-3-33 Spanning Tree Switch Configuration/Status
134