Planet Networking & Communication WGS3-24000 User Manual page 271

Slot/Port - Select the interface number from the dropdown menu. This is the interface that connects to the neighbor
o
router for the given source IP address.
Command Buttons
Submit - Send the updated configuration to the router. Configuration changes take effect immediately. These
o
changes will not be retained across a power cycle unless a save is performed.
Delete - Delete the static entry with the selected Source IP address from the Mroute table.
o
4.7.1.5 Multicast Static Routes Summary
Non-Configurable Data
Source IP - The IP Address that identifies the multicast packet source for this route.
o
Source Mask - The subnet mask applied to the Source IP address.
o
RPF Neighbor - The IP address of the RPF neighbor.
o
Metric - The link state cost of the path to the multicast source. The range is 0 - 255.
o
Slot/Port - The number of the incoming interface whose IP address is used as RPF for the given source IP address.
o
Command Buttons
Refresh - Refresh the data on the screen with the present state of the data in the router.
o
Figure 4-6-53 Milticast Static Routes Summary
271