Table of Contents
Advertisement
The CLI Quick Start up details procedures to quickly become acquainted with the software.
6.1 Quick Starting the Switch
1.
Read the device Installation Guide for the connectivity procedure. In-band connectivity allows access to the software locally
or from a remote workstation. The device must be configured with IP information (IP address, subnet mask, and default
gateway).
2.
Turn the Power ON.
3.
Allow the device to load the software until the login prompt appears. The device initial state is called the default mode.
4.
When the prompt asks for operator login, execute the following steps:
▫
Type the word "admin" in the login area. Since a number of the Quick Setup commands require administrator
account rights, we suggest logging into an administrator account.
▫
Do not enter a password because there is no password in the default mode.
▫
Press the enter key two times.
▫
The CLI User EXEC prompt will be displayed.
▫
Use "enable" to switch to the Privileged EXEC mode from User EXEC.
▫
Use "configure" to switch to the Global Config mode from Privileged EXEC.
▫
Use "exit" to return to the previous mode.
6.2 System Info and System Setup
Quick Start up Software Version Information.
Command
show hardware
(in Privileged EXEC)
Quick Star up Physical Port Data.
Command
Show port all
(in Privileged EXEC)
Allows the user to see the software version the device contains
Machine Model (The type and number of ports the device provides.)
For example:
Machine Model............. 24+2G
24 = 24 10/100 ports
02 = 2 Uplink ports on back of switch
Table 5-1 Quick Start up Software Version Information.
Displays the Ports
slot/port
6. QUICK START UP
Details
Details
312
Advertisement
Table of Contents
