Ip Pimsm Cbsrpreference; Ip Pimsm Cbsrhashmasklength; Ip Pimsm Crppreference; Protocol Independent Multicast - Sparse Mode(Pim-Sm) Commands - Planet Networking & Communication WGS3-24000 User Manual

13.5 Protocol Independent Multicast - Sparse Mode(PIM-SM) Commands

This section provides a detailed explanation of the PIM-SM commands. The commands are divided into the following different
groups:
◆Show commands are used to display device settings, statistics and other information.
◆Configuration commands are used to configure features and options of the switch. For every configuration command there is
a show command that will display the configuration setting.

13.5.1 ip pimsm cbsrpreference

This command is used to configure the CBSR preference for a particular PIM-SM interface. The range of CBSR preference
is –1 to 255.
▫
Default 0
▫
Format ip pimsm cbsrpreference <-1-255>
▫
Mode Interface Config
no ip pimsm cbsrpreference
This command is used to reset the CBSR preference for a particular PIM-SM interface to the default value.
▫
Format no ip pimsm cbsrpreference
▫
Mode Interface Config

13.5.2 ip pimsm cbsrhashmasklength

This command is used to configure the CBSR hash mask length to be advertised in bootstrap messages for a particular PIM-SM
interface. This hash mask length will be used in the hash algorithm for selecting the RP for a particular group. The valid range is
0 - 32. The default value is 30.
▫
Default 30
▫
Format ip pimsm cbsrhashmasklength <0-32>
▫
Mode Interface Config
no ip pimsm cbsrhashmasklength
This command is used to reset the CBSR hash mask length for a particular PIM-SM interface to the default value.
▫
Format no ip pimsm cbsrhashmasklength
▫
Mode Interface Config

13.5.3 ip pimsm crppreference

This command is used to configure the Candidate Rendezvous Point (CRP) for a particular PIM-SM interface. The valid values
510