Planet Networking & Communication WGS3-24000 User Manual page 60

Port Role - Each MST Bridge Port that is enabled is assigned a Port Role for each spanning tree. The port role will
。
be one of the following values: Root Port, Designated Port, Alternate Port, Backup Port, Master Port or Disabled
Port.
Admin Mode - The Port control administration state. The port must be enabled in order for it to be allowed into the
。
network. The factory default is enabled.
LACP Mode - Indicates the Link Aggregation Control Protocol administration state. The mode must be enabled in
。
order for the port to participate in Link Aggregation.
Physical Mode - Indicates the port speed and duplex mode. In auto-negotiation mode the duplex mode and speed
。
are set from the auto-negotiation process.
Physical Status - Indicates the port speed and duplex mode.
。
Link Status - Indicates whether the Link is up or down.
。
Link Trap - Indicates whether or not the port will send a trap when link status changes.
。
ifIndex - Indicates the ifIndex of the interface table entry associated with this port.
。
4.2.6.3 Port Mirroring
Use this page to configure the port mirror function.
Configurable Data
Session ID - A session ID or "All Sessions" option may be selected. By default the First Session is selected.
。
Session Mode - Specifies the Session Mode for a selected session ID. By default Session Mode is enabled.
。
Source Port(s) - Specifies the configured port(s) as mirrored port(s). Traffic of the configured port(s) is sent to the
。
probe port.
Destination Port - Acts as a probe port and will recieve all the traffic from configured mirrored port(s). Default value
。
is blank.
Command Buttons
Submit - Send the updated screen to the switch and cause the changes to take effect on the switch.
。
Figure 4-2-29 Multiple Port Mirroring
60