Table of Contents
Advertisement
Area ID
Type of Service
Metric Val
Import Summary LSA
12.7.55 show ip ospf virtual-link
This command displays the OSPF Virtual Interface information for a specific area and neighbor. The <areaid> parameter
identifies the area and the <neighbor> parameter identifies the neighbor's Router ID.
▫
Format
show ip ospf virtual-link <areaid> <neighbor>
▫
Modes
Privileged EXEC
User EXEC
Area ID
Neighbor Router ID
Hello Interval
Dead Interval
Iftransit Delay Interval
Retransmit Interval
Authentication Type
State
Neighbor State
12.7.56 show ip ospf virtual-link brief
This command displays the OSPF Virtual Interface information for all areas in the system.
▫
Format
show ip ospf virtual-link brief
▫
Modes
Privileged EXEC
User EXEC
Is a 32-bit identifier for the created stub area
Is the type of service associated with the stub metric.
ports Normal TOS.
The metric value is applied based on the TOS. It defaults to the least metric of the type of
service among the interfaces to other areas. The OSPF cost for a route is a function of the
metric value.
Controls the import of summary LSAs into stub areas
The area id of the requested OSPF area
The input neighbor Router ID
The configured hello interval for the OSPF virtual interface.
The configured dead interval for the OSPF virtual interface.
The configured transit delay for the OSPF virtual interface.
The configured retransmit interval for the OSPF virtual interface.
The configured authentication type of the OSPF virtual interface.
The OSPF Interface States are: down, loopback, waiting, point-to-point, designated router,
and backup designated router. This is the state of the OSPF interface.
The neighbor state.
FASTPATH only sup
476
Advertisement
Table of Contents
