Planet Networking & Communication WGS3-24000 User Manual page 280

Version 1 Host Timer - The time remaining until the local router will assume that there are no longer any IGMP
o
version 1 members on the IP subnet attached to this interface. When an IGMPv1 membership report is received, this
timer is reset to the group membership timer. While this timer is non-zero, the local router ignores any IGMPv2 leave
messages for this group that it receives on the selected interface. This field is displayed only if the interface is
configured for IGMP version 1.
Version 2 Host Timer - The time remaining until the local router will assume that there are no longer any IGMP
o
version 2 members on the IP subnet attached to this interface. When an IGMPv2 membership report is received, this
timer is reset to the group membership timer. While this timer is non-zero, the local router ignores any IGMPv1 and
IGMPv3 leave messages for this group that it receives on the selected interface. This field is displayed only if the
interface is configured for IGMP version 2.
Compatibility - This parameter shows group compatibility mode (v1, v2 and v3) for this group on the specified
o
interface.
Filter Mode - The source filter mode (Include/Exclude/NA) for the specified group on this interface. When NA mode
o
is active the field is blank
Command Buttons
Refresh - Refresh the data on the screen with the present state of the data in the router.
o
4.7.2.5 IGMP Interface Membership Details Info
Selection Criteria
Slot/Port - Select the Slot and port for which data is to be displayed. Slot 0 is the base unit.
o
Multicast Group IP - Select the IP multicast group address for which data is to be displayed. If no group
o
membership reports have been received on the selected interface you will not be able to make this selection, and
none of the non-configurable data will be displayed.
Figure 4-6-61 IGMP InterfaceDetail Membership Info
280