Planet Networking & Communication WGS3-24000 User Manual page 276

Query Max Response Time - Enter the maximum query response time to be advertised in IGMPv2 queries on this
o
interface, in tenths of a second. The default value is 10. Valid values are from (0 to 255) .
Startup Query Interval - Enter the number of seconds between the transmission of startup queries on the selected
o
interface. The valid values are from 1 to 300. The default value is 31.
Startup Query Count - Enter the number of queries to be sent on startup. The valid values are from 1 to 20. The
o
default value is 2.
Last Member Query Interval - Enter the last member query interval in tenths of a second. This the maximum
o
response time to be inserted into group-specific queries sent in response to leave group messages, and is also the
amount of time between group-specific query messages. Valid values are from 0 to 255. The default value is 1. This
value is not used for IGMP version 1.
Last Member Query Count - Enter the number of queries to be sent on receiving a leave group report. Valid values
o
are from 1 to 20. The default value is 2.
Command Buttons
Submit - Send the updated configuration to the router. Configuration changes take effect immediately. These
o
changes will not be retained across a power cycle unless a save is performed.
276