Ip Ospf Transmit-Delay; Ip Ospf Mtu-Ignore; Router-Id (Ospf) - Planet Networking & Communication WGS3-24000 User Manual

▫
Mode Interface Config
no ip ospf retransmit-interval
This command sets the default OSPF retransmit Interval for the specified interface.
▫
Format no ip ospf retransmit-interval
▫
Mode Interface Config

12.7.34 ip ospf transmit-delay

This command sets the OSPF Transit Delay for the specified interface. The transmit delay is specified in seconds. In addition, it
sets the estimated number of seconds it takes to transmit a link state update packet over this interface. Valid values for
<seconds> range from 1 to 3600 (1 hour).
▫
Default 1
▫
Format ip ospf transmit-delay <1-3600>
▫
Mode Interface Config
no ip ospf transmit-delay
This command sets the default OSPF Transit Delay for the specified interface.
▫
Format no ip ospf transmit-delay
▫
Mode Interface Config

12.7.35 ip ospf mtu-ignore

This command disables OSPF maximum transmission unit (MTU) mismatch detection. OSPF Database Description packets
specify the size of the largest IP packet that can be sent without fragmentation on the interface. When a router receives a
Database Description packet, it examines the MTU advertised by the neighbor. By default, if the MTU is larger than the router
can accept, the Database Description packet is rejected and the OSPF adjacency is not established.
▫
Default enabled
▫
Format ip ospf mtu-ignore
▫
Mode Interface Config
no ip ospf mtu-ignore
This command enables the OSPF MTU mismatch detection.
▫
Format no ip ospf mtu-ignore
▫
Mode Interface Config

12.7.36 router-id (OSPF)

This command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id. The <ipaddress> is a configured
value.
462