Monitor Session; Monitor Session Mode; Port Lacpmode - Planet Networking & Communication WGS3-24000 User Manual

<vlanid>. The <macaddr> parameter must be specified as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN.
▫
Format no macfilter addsrc all <macaddr> <vlanid>
▫
Mode Global Config

8.6.11 monitor session

This command configures a probe port and a monitored port for monitor session (port monitoring). The first slot/port is the
source monitored port and the second slot/port is the destination probe port. If this command is executed while port monitoring
is enabled, it will have the effect of changing the probe and monitored port values.
▫
Format monitor session source <slot/port> destination <slot/port>
▫
Mode Global Config
8.6.11.1 no monitor session
This command removes the monitor session (port monitoring) designation from both the source probe port and the destination
monitored port and removes the probe port from all VLANs. The port must be manually re-added to any desired VLANs.
▫
Format no monitor session
▫
Mode Global Config

8.6.12 monitor session mode

This command configures the monitor session (port monitoring) mode to enable. The probe and monitored ports must be
configured before monitor session (port monitoring) can be enabled. If enabled, the probe port will monitor all traffic received
and transmitted on the physical monitored port. It is not necessary to disable port monitoring before modifying the probe and
monitored ports.
▫
Default Disabled
▫
Format monitor session mode
▫
Mode Global Config
8.6.12.1 no monitor session mode
This command sets the monitor session (port monitoring) mode to disable.
▫
Format no monitor session mode
▫
Mode Global Config

8.6.13 port lacpmode

This command enables Link Aggregation Control Protocol (LACP) on a port.
▫
Default Disabled
▫
Format port lacpmode
▫
Mode Interface Config
348