Planet Networking & Communication WGS3-24000 User Manual page 78

Configurable Data
File Type - Specify the type of file you want to upload. The available options are Configuration, Error Log, System
。
Trace, and Trap Log. The factory default is Error Log.
TFTP Server IP Address - Enter the IP address of the TFTP server. The factory default is 0.0.0.0
。
TFTP File Path - Enter the path on the TFTP server where you want to put the file being uploaded. You may enter
。
up to 32 characters. The factory default is blank.
TFTP File Name - Enter the name you want to give the file being uploaded. You may enter up to 32 characters.
。
The factory default is blank.
Start File Transfer - To initiate the upload you need to check this box and then select the submit button.
。
4.2.9.7 Ping
Use this screen to tell the switch to send a Ping request to a specified IP address. You can use this to check whether the switch
can communicate with a particular IP station. Once you click the Submit button, the switch will send three pings and the results
will be displayed below the configurable data. If a reply to the ping is not received, you will see No Reply Received from IP
xxx.xxx.xxx.xxx, otherwise you will see Reply received from IP xxx.xxx.xxx.xxx : (send count = 3, receive count = n).
Configurable Data
IP Address - Enter the IP address of the station you want the switch to ping. The initial value is blank. The IP
。
Address you enter is not retained across a power cycle.
Figure 4-2-46 Upload File from Switch
Figure 4-2-47 Ping
78