Set Gmrp Adminmode; Set Gmrp Interfacemode - Planet Networking & Communication WGS3-24000 User Manual

▫ 1000 centiseconds (10 seconds)
Default
▫
Format set garp timer leaveall all <200-6000>
▫
Mode Global Config
8.6.27.1 no set garp timer leaveall all
This command sets how frequently Leave All PDUs are generated for all ports to 1000 centiseconds (10 seconds).
This command has an effect only when GVRP is enabled.
Note
:
▫
Format no set garp timer leaveall all
▫
Mode Global Config

8.6.28 set gmrp adminmode

This command enables GARP Multicast Registration Protocol (GMRP) on the system. The default value is disable.
▫
Format set gmrp adminmode
▫
Mode Privileged EXEC
8.6.28.1 no set gmrp adminmode
This command disables GARP Multicast Registration Protocol (GMRP) on the system.
▫
Format no set gmrp adminmode
▫
Mode Privileged EXEC

8.6.29 set gmrp interfacemode

This command enables GARP Multicast Registration Protocol on a selected interface. If an interface which has GARP enabled
is enabled for routing or is enlisted as a member of a port-channel (LAG), GARP functionality will be disabled on that interface.
GARP functionality will subsequently be re-enabled if routing is disabled and portchannel (LAG) membership is removed from
an interface that has GARP enabled.
▫ Disabled
Default
▫
Format set gmrp interfacemode
▫
Mode Interface Config
8.6.29.1 no set gmrp interfacemode
This command disables GARP Multicast Registration Protocol on a selected interface. If an interface which has GARP enabled
is enabled for routing or is enlisted as a member of a port-channel (LAG), GARP functionality will be disabled on that interface.
GARP functionality will subsequently be re-enabled if routing is disabled and portchannel (LAG) membership is removed from
an interface that has GARP enabled.
▫
Format no set gmrp interfacemode
▫
Mode Interface Config
354