Planet Networking & Communication WGS3-24000 User Manual page 62

4.2.6.5 Double VLAN Tunneling
Use this page to configure the Doubble VLAN Tunneling.
Selection Criteria
Slot/Port - Select the physical interface for which you want to display or configure data. Select 'All' to set the
。
parameters for all ports to same values.
Configurable Data
Mode - This specifies the administrative mode via which Double VLAN Tagging can be enabled or disabled. The
。
default value for this is Disabled.
Customer ID - This is a 12 bit customer ID which will be used as the last 12 bits of the DVlan tag. The valid range for
。
a customer Id is (0 to 4095). The default customer Id is 0 .
EtherType - The two-byte hex EtherType to be used as the first 16 bits of the DVlan tag.
。
802.1Q Tag - Commonly used tag representing 0x8100
vMAN Tag - Commonly used tag representing 0x88A8
Custom Tag - Configure the EtherType in any range from (0 to 65535)
Command Buttons
Submit - Update the switch with the values on this screen. If you want the switch to retain the new values across a
。
power cycle, you must perform a save.
Figure 4-2-31 Double VLAN Tunneling
62