4.2.6.7 Double VLAN Tunneling Summary
Non-Configurable Data
Slot/Port - The physical interface for which data is being displayed.
。
Mode - This specifies the administrative mode via which Double VLAN Tagging can be enabled or disabled. The
。
default value for this is Disabled.
Customer ID - This is the 12 bit customer ID which will be used as the last 12 bits of the DVlan tag. The valid range
。
for a customer Id is (0 to 4095). The default customer Id is 0 .
EtherType - The two-byte hex EtherType to be used as the first 16 bits of the DVlan tag.
。
802.1Q Tag - Commonly used tag representing 0x8100
vMAN Tag - Commonly used tag representing 0x88A8
Custom Tag - Configure the EtherType in any range from (0 to 65535)
Command Buttons
Refresh - Refresh the data on the screen with the present state of the data in the switch.
Figure 4-2-32 Double VLAN Tunneling Summary
63