Show Ip Igmp; Show Ip Igmp Groups - Planet Networking & Communication WGS3-24000 User Manual

13.3.15 show ip igmp

This command displays the system-wide IGMP information.
▫
Format show ip igmp
▫
Modes Privileged EXEC User EXEC
IGMP Admin Mode
Unit/Slot/Port
Interface Mode
Protocol State

13.3.16 show ip igmp groups

This command displays the registered multicast groups on the interface. If "detail" is specified this command displays the
registered multicast groups on the interface in detail.
▫
Format show ip igmp groups <unit/slot/port> [detail]
▫
Mode Privileged EXEC
If detail is not specified, the following fields are displayed:
IP Address
Subnet Mask
Interface Mode
The following fields are not displayed if the interface is not enabled:
Querier Status
This field displays the administrative status of IGMP. This is a configured value.
Valid unit, slot and port number separated by forward slashes
This field indicates whether IGMP is enabled or disabled on the interface. This is a
configured value.
This field indicates the current state of IGMP on this interface. Possible values are
Operational or Non-Operational.
This displays the IP address of the interface participating in the multicast group.
This displays the subnet mask of the interface participating in the multicast group.
This displays whether IGMP is enabled or disabled on this interface.
This displays whether the interface has IGMP in Querier mode or Non-Querier mode.
503