Bootpdhcprelay Cidoptmode; Show Ip Vrrp Interface Brief; Dhcp And Bootp Relay Commands - Planet Networking & Communication WGS3-24000 User Manual

interface.
▫
Format show ip vrrp interface <slot/port> <vrid>
▫
Modes Privileged EXEC
User EXEC
IP Address
VMAC address
Authentication type
Priority
Advertisement interval
Pre-Empt Mode
Administrative Mode
State

12.5.12 show ip vrrp interface brief

This command displays information about each virtual router configured on the switch. This command takes no options. It
displays information about each virtual router.
▫
Format show ip vrrp interface brief
▫
Modes Privileged EXEC
User EXEC
Interface
VRID
IP Address
Mode
State

12.6 DHCP and BOOTP Relay Commands

This section describes the commands you use to configure BootP/DHCP Relay on the switch. A DHCP relay agent operates at
Layer 3 and forwards DHCP requests and replies between clients and servers when they are not on the same physical subnet.

12.6.1 bootpdhcprelay cidoptmode

This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
▫
Default disabled
▫
Format bootpdhcprelay cidoptmode
This field represents the configured IP Address for the Virtual router.
Represents the VMAC address of the specified router.
Represents the authentication type for the specific virtual router.
Represents the priority value for the specific virtual router.
Represents the advertisement interval for the specific virtual router.
Is the preemption mode configured on the specified virtual router.
Represents the status (Enable or Disable) of the specific router.
Represents the state (Master/backup) of the virtual router.
Valid slot and port number separated by forward slashes.
Represents the router ID of the virtual router.
The virtual router IP address.
Represents whether the virtual router is enabled or disabled.
Represents the state (Master/backup) of the virtual router
448