Planet Networking & Communication WGS3-24000 User Manual page 300

Selection Criteria
Slot/Port - Select the physical interface for which data is to be displayed. There must be configured at least one
o
router interface before displaying data for a PIM-DM interface, otherwise a message will be displayed.
Non-Configurable Data
Interface Mode - Displays the administrative status of PIM-DM for the selected interface. The default is disable.
o
Protocol State - The operational state of the PIM-DM protocol on this interface.
o
Hello Interval - The frequency at which PIM hello messages are transmitted on the selected interface.
o
IP Address - The IP address of the selected interface.
o
Neighbor Count - The number of PIM neighbors on the selected interface.
o
Designated Router - The designated router on the selected PIM interface. For point- to-point interfaces, this will be
o
0.0.0.0.
Neighbor IP - The IP address of the PIM neighbor for which this entry contains information.
o
Uptime - The time since this PIM neighbor (last) became a neighbor of the local router.
o
Expiry Time - The minimum time remaining before this PIM neighbor will be aged out.
o
Command Buttons
Refresh - Refresh the data on the screen with the present state of the data in the router.
o
300