Expedite Percent; Mark Ip-Dscp - Planet Networking & Communication WGS3-24000 User Manual

Note The actual bandwidth allocation does not occur until the policy is attached to an interface in a particular direction.
:
Note The expedite kbps and percent commands are alternative ways to specify the same expedite policy attribute.
:
▫
Format expedite kbps <1-4294967295> [1-128]
▫
Mode Policy-Class-Map Config
▫ Restrictions - The sum of the committed information rate values for all bandwidth and expedite commands defined within
a policy must not exceed the available link bandwidth of the interface to which that policy is assigned. Violation of this
requirement shall prevent successful attachment of a policy to the interface, or shall cause this command to fail if the
policy is already in service on one or more interfaces.
▫ Policy Type - Out
▫ Incompatibilities - Bandwidth (all forms), Shape Peak

9.5.5 expedite percent

This command identifies the maximum guaranteed amount of bandwidth to be reserved for the specified class instance within
the named policy using a relative rate notation. The committed information rate is specified as a percentage of total link capacity
and is an integer from 1 to 100. The optional committed burst size is specified in kilobytes (KB) as an integer from 1 to 128, with
a default of 4.
The actual bandwidth allocation does not occur until the policy is attached to an interface in a particular direction.
Note
:
Note The expedite kbps and percent commands are alternative ways to specify the same expedite policy attribute.
:
▫
Format expedite percent <1-100> [1-128]
▫
Mode Policy-Class-Map Config
▫ Restrictions - The sum of the committed information rate values for all bandwidth and expedite commands defined within
a policy must not exceed the available link bandwidth of the interface to which that policy is assigned. Violation of this
requirement shall prevent successful attachment of a policy to the interface, or shall cause this command to fail if the
policy is already in service on one or more interfaces.
▫ Policy Type - Out
▫ Incompatibilities - Bandwidth (all forms), Shape Peak

9.5.6 mark ip-dscp

This command marks all packets for the associated traffic stream with the specified IP DSCP value. The <dscpval> value is
specified as either an integer from 0 to 63, or symbolically through one of the following keywords: af11, af12, af13, af21, af22,
af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.
▫
Format mark ip-dscp <dscpval>
▫
Mode Policy-Class-Map Config
▫ Policy Type - In
▫ Incompatibilities - Mark IP Precedence, Police (all forms)
389