DataKinetics DSC110 User Manual page 94

7.16.17 Configuration Remote Data Centre Initiate
CNRDI Configuration Remote Data Centre Initiate
This command is used to configure Remote Data Centre (RDC) so that data from
periodic report or continuous recording can be transferred to that location. The
connection itself is established when the RDC is unblocked.
Note: If an RDC has previously been ended but a file transfer was already in
progress subsequent CNRDIs using that RDC will fail with "NO SYSTEM
RESOURCES" until the file transfer has completed.
Prerequisites The Remote data Centre is not already initiated.
The IP address is not already in use.
Remote Data Operation must be allowed by the system.
Syntax CNRDI:RDC=,IPADDR=,USER=,PASSWORD=,[LABEL=,];
Attributes CONFIG
Example CNRDI:RDC=1,IPADDR=255.123.0.124,USER=JOHN,PASSWORD=BAZZA123;
7.16.18 Configuration Remote Data Centre Change
CNRDC Configuration Remote Data Centre Change
This command is used to change the configuration of a Remote Data Centre
(RDC).
Prerequisites The RDC is already initiated and blocked.
If specified, the IP address is not already in use.
Remote Data Operation must be allowed by the system.
Syntax CNRDC:RDC=,{[IPADDR=,][USER=,][PASSWORD=,][LABEL=,]};
Attributes CONFIG
Example CNRDC:RDC=1,IPADDR=255.123.0.124,USER=JOHN,PASSWORD=BAZZA123;
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 94