Command Definitions - DataKinetics DSC110 User Manual

7.12 Command Definitions

7.12.1 Command Groups
The commands are broken down into a number of command groups as follows:-
Alarms
Access Side Signalling
Circuit Assignment
Configuration
SS7 Signalling
MMI
Maintenance
Measurements
Remote Data Centre
Routing
Status
7.12.2 Command Notation
The following conventions are used in the command definitions:
•
Items in square brackets [ ] are optional.
•
Items separated by a vertical bar | are alternatives, only one of which may be used.
•
Curly brackets { } are used to designate a group of optional items of which at least one must be
selected.
•
The sequence of three dots ... is used to indicate that a number of values may be entered,
linked by the & or && operator.
7.12.3 Command Attributes
The following symbols are used to indicate command attributes:
CONFIG The command affects configuration data.
PROMPT A "DANGEROUS" command which must be confirmed by the operator.
RDC This command only applies when the Remote Data Centre Option is fitted.
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 73