DataKinetics DSC110 User Manual page 103

7.16.33 Configuration Voice Resource Initiate
CNVRI Configuration Voice Resource Initiate
This command is used to initiate a voice resource.
Syntax CNVRI:VRS=,EQU=;
Prerequisites The specified voice resource has not already been initiated.
The board on which the EQU exists has been initiated and the EQU must be within
the range supported by the board.
The board on which the EQU exists must have a signalling type of VOICE
The voice processor specified by the EQU parameter must not be assigned
elsewhere in the system.
Only EQU signalling processors 1 and 2 can be used.
Attributes CONFIG
Example CNVRI:VRS=1,EQU=5-1;
7.16.34 Configuration Voice Resource End
CNVRE Configuration Voice Resource End
This command is used to end the assignment of a voice resource.
Syntax CNVRE:VRS=;
Prerequisites The voice resource must already have been initiated.
The voice resource must be blocked.
Attributes CONFIG
Example CNVRE:VRS=1;
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 103