DataKinetics DSC110 User Manual page 139

7.23.2 Routing Digit Analysis Change
RTDAC
Syntax
Prerequisites
Limitations
Attributes
Example
DataKinetics DSC110 / DSC210 User Manual Issue 12
Routing Digit Analysis Change
This command is used to change the outgoing route or secondary point of origin
that is associated with an already existing digit analysis index/called party digits
key.
N.B. If a calling party category or nature of address is specified in the DIGS field
then it must left filled with 0's so that the digit string is 3 digits long e.g. a CPC of
10 would be digits 010.
RTDAI: DAI=,DIGS=,[OGR=,][SPOR=,];
The specified digit analysis index and digit combination has not already been
initiated. The combination is also not allowed if the digits form the prefix of a
previously specified digit string or a previously specified digit string forms the
prefix of the specified digit string (e.g. "DAI 1", "DIGS 01" cannot be initiated if
"DAI 1", DIGS "01425" have previously been initiated. And vice versa).
As a result of this command either a default outgoing route or secondary point of
origin must be specified and. if specified, already initiated.
As a result of this command both a default outgoing route and secondary point of
origin cannot be specified.
If the changing outgoing route or secondary point of origin leading to an outgoing
route is circuit mapped then the circuit groups involved must be blocked.
If the new route secondary point of origin is circuit mapped then the circuit groups
involved must be blocked.
Routing using a secondary point of origin can only result in up to 5 secondary
points of origin before achieving an outgoing route.
CONFIG
RTDAC:DAI=1,DIGS=01425,OGR=22;
Page 139