DataKinetics DSC110 User Manual page 84

7.15.5 Circuit Assignment Device Initiate
CADEI Circuit Assignment Device Initiate
This command is used to add a device or CIC to a circuit group.
Syntax CADEI:CGRP=,DEV=...;
CADEI:CGRP=,CIC=...;
Prerequisites The circuit group must already have been initiated.
All devices or CICs specified must not already have been assigned to a circuit
group.
If the circuit group exists on a PCM then the device being assigned must be in a
valid range for the PCM type (up to 1:31 for E1 PCMs and 1:24 for T1 PCMs).
CICs cannot be specified for Access Side Groups.
For voice groups, since devices directly relate to timeslots, device 0 cannot be
specified.
For voice devices the timeslot relating to the device must not be assigned
elsewhere on the system.
Since Access Side links use timeslot 16 for signalling this device cannot be
specified for Access Side groups.
The first device number + the base cic number must not result in a negative
number.
The associated circuit group must be blocked.
Attributes CONFIG
Example CADEI:CGRP=1,DEV=14;
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 84