DataKinetics DSC110 User Manual page 50

IHEC The setting of the incoming half echo
cancellor indication
Format x-y
x – processing for received values
y – processing for sent values
0 – Pass the indication transparently
1 – Set value to indicate incoming half
echo cancellor not included.
2 – Set value to indicate incoming half
echo cancellor included.
INT The setting of the national/international
indicator
Format x-y
x – processing for received values
y – processing for sent values
0 – Pass the indication transparently
1 – Set value to indicate national call.
2 – Set value to indicate international
call.
IPADDR Internet Protocol (IP) Address of the
converter specified using dot notation:
www.xxx.yyy.zzz
ISC Intelligent Service Control
Used to activate ISC on the DSC210.
ISM Intelligent Service Mode
Used to select a particular ISC service
ISMD Integrated services mode:-
0 = Unchanged level of service
1 = Reduce level of service to SS7
2 = Reduce level of service to POTS
3 = Reduce level of service from ISDN
ISTAB Table id used by Intelligent Service
Control
ISUP Whether ISUP is activated on the
converter.
ITS The input timeslot in a cross
connection (in the case of a duplex
cross connection this is also the output
timeslot for the reverse direction).
Format: xx-y-zz
xx = board position (BPOS)
y = PCM within a board
zz = Timeslot
LCMD Reserved.
DataKinetics DSC110 / DSC210 User Manual Issue 12
X:0:2 Default = 0-0
y:0:2
X:0:2 Default = 0-0
y:0:2
www – 0:255 Default =
xxx - 0:255 0.0.0.0
yyy - 0:255
zzz - 0:255
Y,N Default = N
1:10 Default = 0
0:3 Default = 0
0,1-50 Default = 0
Y,N Default = N
xx: 5:20
y: 1,2
zz: 1:31
0:2 Default = 0
Page 50