DataKinetics DSC110 User Manual page 145

7.23.10 Routing Outgoing Route End
RTORE
Syntax
Prerequisites
Attributes
Example
DataKinetics DSC110 / DSC210 User Manual Issue 12
Routing Outgoing Route End
This command is used to end a route. It will also remove the association of a
circuit group to the route.
RTORE:OGR=;
The specified route must already have been initiated.
The route cannot be attached to any digit analysis mapping.
If the route is involved in circuit mapping then it can only be ended if the circuit
groups involved are blocked.
The outgoing route cannot be ended if it is associated with a periodic report or
continuous record.
An outgoing route cannot be ended if it is a next route associated with another
outgoing route.
CONFIG
RTORE:OGR=3;
Page 145