DataKinetics DSC110 User Manual page 130

7.22.4 Remote Data Centre Continuous Record Initiate
RDCRI Remote Data Centre Continuous Record Initiate
This command initiates a continuous record collection for which collected data is
transferred via Ethernet to a Remote Data Centre (RDC).
Continuous records can be specified for billing or call failures.
The period is the maximum amount of time allowed before the transfer of a block
of continuous records must be performed.
The minimum number of records that must be collected before the transfer of
records can be performed should be specified.
The label will be used as the directory name on the remote data centre the files are
written to.
Data can be added/deleted from the continuous records using the RDCDI/RDCDE
commands.
Prerequisites The record has not already been initiated.
The converter must have an IPADDR.
If the record is an alarm record then an alarm record must not already exist.
RDC1 must already be initiated.
If specified RDC2 must already be initiated
If specified RDC2 must not equal RDC1.
Limitations Before transfer to a RDC can take place the directory, represented by the label,
must exist on the remote site.
PERIOD must be in the range 30 seconds to 30 minutes.
Syntax RDCRI:RECORD=,CRTYPE=,PERIOD=,MINREC=,RDC1=,LABEL=,[RDC2=,];
Attributes CONFIG, RDC
Example RDCRI:RECORD=1,CRTYPE=BILLING,PERIOD=00:05:00,MINREC=100,
RDC1=1,LABEL=BILLING;
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 130