DataKinetics DSC110 User Manual page 7

Allows the user to allocate b CIC of 0 or above to any device on the
12 12-Oct-01
system by supporting negative BCICs.
Added the ability to specify a default Japan Specific Carrier
information code by making user of the CG2PRE parameter.
Support for on box calling party number validation added using LSM.
Support for the North American ISDN protocol (NI2) as well as T1 on
ISDN boards.
CNUPI modified to support the ability to perform remote software
and configuration update from a remote data centre or locally from
floppy disk. CNBUI modified to back up configuration to a remote
data center.
Software update procedures to provide support for multiple
distribution binaries.
Enhance routing capabilities so the user is able to route on the
calling party number, CPC, called party number nature of address
and calling party number nature of address by allowing the
configuration of a DAMD on a Point of Origin basis.
Added secondary points of origin (SPOR) on points of origin or in
digit analysis to allow support for multi stage routing allowing the
user to analyse different selection criteria (e.g. CPC, called party
number) before selecting the outgoing route.
Allow the user to manipulate satellite indicators in initial address
messages using the SAT parameter on a per circuit group basis.
Allow the user to generate a bearer capability parameter based of a
received transmission medium requirement parameter using the
TMRM parameter on a circuit group basis.
Support new ASTYPE variants Q931-1 and Q931-2 to support
partner blocking on the Q931 side so that when hardware blocking
occurs on the SS7 side the Q931 signalling link is taken out of
service.
Allow the user to configure the maximum number (k) of I frames on
Q921 by configuring the L2K parameter on a per circuit group basis.
Support new COT mode to allow incoming continuity checks..
Configuration added to allow the user configure and generate an
'early' address complete message by using the BWM parameter on
a per outgoing route basis.
Support compatibility CRC4 operation (to allow interworking to non
CRC4).
New ASTYPEs DPNSS-2 and DPNSS-3 introduced to allow data
calls.
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 7