DataKinetics DSC110 User Manual page 5

DPNSS signalling system added.
10 19-May-00
Added custom profiles to configure specific indicators for the calling
and called party number using the CPCGI, CPCGC, CPCGE,
CPCGP, CPCDI, CPCDC, CPCDE, and CPCDP commands.
Added the ability for the user to added/change a second calling party
number using the CG2PRE, CG2DL parameters.
Moved the ability to set the calling number restriction indication from
the CGMD to the calling party number profile.
Moved the ability to request a calling party number parameter from
the CGMD to the new RCG parameter.
Moved the ability to set the called number nature of address
indicator from the CDMD parameter to the called party number
profile.
Increased the number of prefix digits supported by CDPRE to 16.
Allow User to set a default CPC on a per circuit group basis.
Supports the ability to transit continuity indicators using new
parameter COT.
Allows the ability to upload from the remote data centre a
customised set of clearing cause mapping tables.
The USC, USM and USTAB parameter have been changed to be
ISC, ISM and ISTBL respectively.
Added CHG to the outgoing route to control the setting of the charge
indication in the backward direction.
Added CONV timers T12, T13 and T14 and added TANS to the
outgoing route to allow the user to control the time to answer on an
outgoing route basis.
Added optional password control of the second serial and 2 telnet
ports using the new PASSWORD parameter specified on a per
system basis.
Introduced the LSM parameter on a point of origin and outgoing
route basis to allow the user to specify the local service mode. This
parameter will be used to specify cli authorisation and insertion
instead of using the CGMD parameter. When uploading local
service control table a DTYPE of LSC will be used instead of
CLIAUTH.
Introduced number translation as part of local service control which
is activated using the TRANS parameter specified on a per system
basis.
Added transmission medium requirement mode to allow the user to
modify the values of the transmission medium requirement
parameter.
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 5