DataKinetics DSC110 User Manual page 136

7.22.12 Remote Data Centre Periodic Report Change
RDPRC Remote Data Centre Periodic Report Change
This command changes parameters relating to a report collection period for which
data is collected and transferred over Ethernet to a Remote Data Centre (RDC).
Reports for circuit group and outgoing route traffic measurements can be specified.
The label is used as the directory name on the remote data centre the files are
written to.
The period is the interval between which data is collected, it will be rounded to the
nearest 5 minute interval.
Data can be added/deleted from the periodic report using the RDPDI/RDPDE
commands.
Prerequisites The report must already be initiated.
If specified RDC2 cannot have the same value as RDC1.
If specified RDC1 must already be initiated.
If specified RDC2 must already be initiated.
Limitations Before transfer to an RDC can take place the directory, represented by the label,
must exist on the remote site.
Syntax RDPRC:REPORT=,[PERIOD=,][LABEL=,][RDC1=,][RDC2=,][RESET=,];
Attributes CONFIG, RDC
Example RDPRC:REPORT=1,PRTYPE=MSOGR,PERIOD=01:00:00,RDC1=1,
LABEL=ROUTES;
7.22.13 Remote Data Centre Periodic Report End
RDPRE Remote Data Centre Periodic Report End
This command ends a periodic report.
Prerequisites The report has already been initiated.
There is no periodic data associated with the periodic report.
Syntax RDPRE:REPORT=;
Attributes CONFIG, RDC
Example RDPRE:REPORT=1;
DataKinetics DSC110 / DSC210 User Manual Issue 12 Page 136