DataKinetics DSC110 User Manual page 119

7.19.4 MMI Port Change
MMPTC MMI Port Change
This command sets the format of the data on the other serial data port to the one
being used for the current log-on session.
Syntax MMPTC:PORT=,{[BAUD=,][DBITS=,][PARITY=,][SBITS=,][LINES=,]
Prerequisites No user must be logged on to the port affected.
For the telnet ports only the LINES parameter may be changed.
Attributes CONFIG
Example MMPTC:PORT=1,BAUD=300;
MMPTC:PORT=2,SBITS=2;
7.19.5 MMI Port Print
MMPTP MMI Port Print
This command gives a print-out of the attributes of the serial port. Where the
parameter PORT is omitted, the print-out provided will be for all ports.
The connected port executing this command is marked with a "*".
Syntax MMPTP[:PORT=];
Attributes None.
Example MMPTP:PORT=1;
MMPTP;
Output format
Serial Port Configuration
PORT BAUD
1 9600
2 1200
3
4
EXECUTED
DataKinetics DSC110 / DSC210 User Manual Issue 12
[PTMODE=,]};
DBITS SBITS PARITY
8 1 NONE
7 2 EVEN
LINES PTMODE CONNECTED
20 DTRDSR *
8 NONE
25 TELNET
25 TELNET
Page 119